"3Dprinting Markers" Topic
2 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Return to the 3Dprinting Markers Article
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase ArticleLooking for a way to mark explosions or fire?
Featured Profile ArticleThe final installment of our ReaperCon report.
Featured Book Review
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
Waco Joe | 16 Jun 2017 7:19 a.m. PST |
I have had issues from time to time with flat pieces curling up at the ends and I have a heated bed. Using PLA I finally found a sweet spot of using a bed temp of 65 degrees instead of of 55, a nozzle temp of 230 instead of the default 215 and using a 3-5mm brim. The combo of higher temps and brim seem to fix the problem. Along the line of markers, I integrated a marker holder into some of my movement trays. This tray is designed for holding my WWS figures mounted on 2 inch bases. I am playing around with using All The King's Men rules which calls for figure removal and a status of green/yellow/red. I added a small part to the tray to hold a small die and a unit status indicator.
Nice and simple and I don't have to worry about the markers getting separated from the unit. |
Editor in Chief Bill | 16 Jun 2017 8:09 a.m. PST |
|
|