"American Bell UH-1H Iroquois Helicopter - With Guns" Topic
6 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Remember that you can Stifle members so that you don't have to read their posts.
For more information, see the TMP FAQ.
Return to the American Bell UH-1H Iroquois Helicopter - With Guns News
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article Need some low-pressure clamps?
Featured Workbench Article How to individually base 3" mini-trees for wargaming.
Featured Profile Article What fun can be found in an inexpensive pack of plastic 'reptiles'?
|
| boggler | 26 Oct 2018 2:07 a.m. PST |
Now, if that was a flying banana, a Chickasaw, Choctaw or an early Wessex, I'd be a very happy chap. |
| Editor Alexa | 26 Oct 2018 4:07 a.m. PST |
Look's good and nice.
Good job! |
troopwo  | 26 Oct 2018 6:21 a.m. PST |
I love how you are adding to your rnges daily!
Well done. |
| crazycaptain | 26 Oct 2018 7:12 a.m. PST |
This is cool, but how do you get rid of all the ridges in these 3D printed models. My brother has a 3D printer and what it has produced is cool, but suffers from the same problem. Thoughts? |
| Gelrir | 26 Oct 2018 1:21 p.m. PST |
There are ways to do so. Sanding would be possible, but annoying at this scale. Coating with self-leveling epoxy; or "melting" with the appropriate solvent. The actual solvent varies by the type of 3D printing material used -- acetone in the case of ABS. |
| jdginaz | 26 Oct 2018 7:29 p.m. PST |
Just need one armed with just rockets as an ARA (Arial Rocket Artillery)
|
|
