"DoBPOD: New Franks & LOTR POD Miniatures" Topic
4 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Remember that you can Stifle members so that you don't have to read their posts.
For more information, see the TMP FAQ.
Return to the DoBPOD: New Franks & LOTR POD Miniatures News
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article Hobby brushes direct from Sri Lanka.
Featured Workbench Article
Featured Profile Article There has been a fire, and  Editor Gwen  has lost everything.
Featured Book Review
|
myxemail  | 21 May 2024 11:25 a.m. PST |
I saw your sample prints at Huzzah this past weekend. The figures looked great, and the level of detail was very nice. I did not notice any lines or other printing issues. Very clean figures |
greenknight4  | 21 May 2024 1:58 p.m. PST |
Thank you. You rarely get lines with resin printed 3D prints. |
 Extra Crispy | 22 May 2024 8:04 a.m. PST |
Do the figures have plinths? I get nervous when I'm trying to glue a figure to a base with just two feet – just not a lot of surface area for glue to hold. |
| greenknight4 | 23 May 2024 5:35 a.m. PST |
By plinth do you mean a base or pins to a base. Most do not but I have no issue gluing them. |
|
shows one way to base 15mm figures on a stand.