"Premo, Fimo, Kato, Sculpey for Wargaming Terrain?" Topic
7 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the Terrain and Scenics Message Board Back to the Sculpting Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase ArticleHobby brushes direct from Sri Lanka.
Featured Profile ArticleThanks to the generosity of TMP readers, there has been much progress in building a new home for our staff editor and her family, evicted from their home.
Current Poll
Featured Book Review
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
Cacique Caribe | 10 Mar 2006 9:10 p.m. PST |
There is all sort of sites and tutorials for the general use of polymer clays: link sculpey.com link etc. However, has anyone done tutorials for wargaming terrain applications? Thanks. CC |
Dave Crowell | 11 Mar 2006 7:09 a.m. PST |
I have not done a turorial, but I do use the stuff. It is great. For me it is more readily accessible than Greenstuff. I have even sculpted entire minis out of it. My wooly rhino for Tusk is a great match to the Irregular dinos. |
Roll Again | 11 Mar 2006 9:00 a.m. PST |
I've made a large (for me) Femur Island, for Pirates of the Caribbean. Reaction was mixed. I've used Sculpey to adhere a figure to a penny sized object, then more Sculpey to texture that base, then pop the lot in the oven at 275* for 15 minutes to solidify it. Works well. I suppose washers would work as well, just as long as the base is metal. Magnets survive the process too. I'm making asteroids for Full Thrust out of Sculpey. ROll a bit flat, texture with a special rolling pin with holes drilled in it; wrap the Sculpey carefully around a pin head, leaving it somewhat hollow; stick the asteroid pins into a sacrificial blob of Sculpey to hold them upright; then, once out of the oven, hold the pin with pliers, heat the pointy end and insert in a black flight stand. The final appearence, with 6 blackwashed-grey-drybrushed asteroids sticking up around the flightbase is excellent. Sorry, I have no picture uploading equipment to illustrate this. |
Go0gleplex | 11 Mar 2006 9:45 a.m. PST |
another way you could try this to produce asteroids is to use a core of aluminum foil or such, wrap the core with about 1/16" thick blanket of sculpty, then use another bit of wadded aluminum foil to 'press the sculpty' into the core foil. Be sure to wet down your pressing foil to reduce stickage. Cook it and you should get an interestingly textured 'roid. |
Sumatran Rat Monkey | 11 Mar 2006 2:01 p.m. PST |
I could be mistaken, but I believe Seth Nash sculpts in Fimo, with fantastic results (check out the Jotun he did for Hasslefree). - Monk |
ming31 | 11 Mar 2006 9:12 p.m. PST |
Large " Garage " kits aare almost all sculpted with Sculpey . Gremlins.com has the large kits . and some sculpting ideas . for bigger kits. |
Cacique Caribe | 11 Mar 2006 11:12 p.m. PST |
|
|