"WIP2 PzIVHs 22nd Pz Regt" Topic
4 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Remember that you can Stifle members so that you don't have to read their posts.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board Back to the WWII Land Gallery Message Board Back to the Blogs of War Message Board Back to the 20mm WWII Message Board Back to the Wargaming in Australia Message Board
Areas of InterestGeneral
World War Two on the Land
Featured Hobby News Article
Featured Link
Featured Ruleset
Rating: 
Featured Profile Article
Current Poll
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
| Gunner Dunbar | 23 May 2024 2:15 a.m. PST |
Hi guys Got some details painted on the Pz IVs, added chipping, filters and markings, I didn't have any white turret numbers, (the numbers may actually have been yellow, but I'm going with white) so I used black numbers as a guide and re painted white, 6x Pz IVs and a command Pz IV representing the 3rd company, 1st Battalion, 22nd Pz regt, plus the battalion HQ, with the commander in a Pz IIIL (yet to be painted) and 2 Pz IVHs, as well as the Laffly S45t as a recovery vehicle (I'll be adding more recovery vehicles more for modelling purposes) next I'll add a pin wash, give a dry brush, highlight some details, then start on the weathering.
link
|
| Disco Joe | 23 May 2024 4:41 a.m. PST |
|
| Captain Pete | 23 May 2024 6:30 a.m. PST |
Those look great, Gunner! |
 Dal Gavan  | 23 May 2024 6:32 a.m. PST |
Good work, mate. You're really churning them out. |
|
discusses the limitations and challenges of working with a low-end 3Dprinter.
