"Norwegian NM-116 Panzerjager 1/100 3D Print File" Topic

3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please avoid recent politics on the forums.

For more information, see the TMP FAQ.

Back to the Cold War (1946-1989) Message Board

Back to the 3DPrinting Message Board

Areas of Interest

General
Modern

Featured Hobby News Article

Contacting Mark Lanckham of Griffin Miniatures

Featured Recent Link

Yarkshire Gamer Podcast - Episode 21 - Gerry Elliott - Wargames Holiday Centre and The Situation Room

Featured Showcase Article

Stuff It! (In a Box)

Editor in Chief Bill worries about not losing his rules stuff.

Featured Workbench Article

Painting Copplestone's News Crew

Dentatus thinks Mark's work is among the best available for all-around gaming and painting.

Featured Profile Article

Yad Mordechai/Deir Suneid

The first of a series of reports from sargonII, who is currently traveling in the Middle East.

Featured Book Review

Quarry's Cut

Dan Cyr	07 Feb 2024 3:50 p.m. PST
Anyone know where I could find a file of this modified M-24 Chaffee tank used by Norwegian army during the Cold War? Thanks in advance. Dan
mckrok	09 Feb 2024 1:42 p.m. PST
link I cannot vouch for this vendor, but they are on my 'give them a shot' list. pjm
ROUWetPatchBehindTheSofa	11 Feb 2024 9:39 a.m. PST
If you can afford it resin is probably the way to go. A couple of 1:144 resin prints passed through my hands and they were very clean.

Sorry - only verified members can post on the forums.