Help support TMP


"Filling the injection port hole" Topic


3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please don't make fun of others' membernames.

For more information, see the TMP FAQ.


Back to the Plastic Army Men Message Board


Areas of Interest

Toy Gaming

Featured Hobby News Article


Featured Link


Top-Rated Ruleset

HeroScape


Rating: gold star gold star gold star gold star gold star gold star gold star 


Featured Workbench Article

15mm Hive Mind Installation

Every army in ASL needs an Installation.


Featured Profile Article

Report from Spring Gathering VI

Paul Glasser reports on the debut of Axis and Allies: Guadalcanal and the North African expansion.


1,280 hits since 3 Dec 2023
©1994-2026 Bill Armintrout
Comments or corrections?


TMP logo

Membership

Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
Windward03 Dec 2023 11:16 a.m. PST

Looking at my surfers, they have these obvious badly placed rings. I'll need to fill them. Suggestions on what to fill with?

Zephyr103 Dec 2023 2:21 p.m. PST

Durham's water putty, plaster, acrylic caulking (probably your best bet… ;-)

Sgt Slag03 Dec 2023 3:44 p.m. PST

Any epoxy putty should work: JB Weld, Green Stuff, etc. Hot Glue will work, as well. Press kitchen parchment paper against the figure to smooth it -- virtually nothing will stick to it. Hot Glue may be challenging, but it will adhere to the plastic quite well. Cheers!

Sorry - only verified members can post on the forums.