Help support TMP


"Running from close combat" Topic


5 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please don't call someone a Nazi unless they really are a Nazi.

For more information, see the TMP FAQ.


Back to The Sword and The Flame Message Board


Areas of Interest

19th Century

Featured Hobby News Article


Featured Ruleset

Age of Iron


Rating: gold star gold star gold star gold star gold star gold star gold star 


Featured Showcase Article

28mm Acolyte Vampires

Blue Table Painting does some junior vampires for us.


Featured Profile Article

Dung Gate

For the time being, the last in our series of articles on the gates of Old Jerusalem.


Featured Book Review


913 hits since 3 Nov 2023
©1994-2025 Bill Armintrout
Comments or corrections?

bobspruster Supporting Member of TMP03 Nov 2023 9:59 a.m. PST

The rules say that an individual figure who loses (not a casualty) will run from the melee. Assuming he does not become shaken at any point, how far from the site of the melee will he run? The rules don't specify.

Personal logo The Virtual Armchair General Sponsoring Member of TMP03 Nov 2023 10:19 a.m. PST

Just move him a couple of inches to the rear.

When the Melee has been decided, he will either rejoin his victorious unit, or participate in their retreat.

TVAG

bobspruster Supporting Member of TMP03 Nov 2023 1:51 p.m. PST

Thanks, guys, I wasn't too far off the mark, then. I was having the figs fall back about 4 inches. One thing I have done, though, is have the movement required by the runners or stragglers to rejoin their units deducted from the movement their units could make.
Thanks again,
Bob

nnascati Supporting Member of TMP05 Nov 2023 5:51 p.m. PST

I've always done 6 inched away from the melee.

MarauderMike22 Nov 2023 11:02 p.m. PST

I have always done just far enough away so you know not to count in next round of melee, no set distance.

Sorry - only verified members can post on the forums.