"Gates for Gasland" Topic
1 Post
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
For more information, see the TMP FAQ.
Back to the Post-Apocalypse Discussion Message Board Back to the Zombies Message Board Back to the Terrain and Scenics Message Board
Areas of InterestGeneral
World War Two on the Land
Modern
Science Fiction
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article From a little-known range of science-fiction microarmor: the Heavy Hover Tank from C in C.
Featured Workbench Article With clean lines and not a lot of clutter, Minidragon  says these figures are a painter's dream!
Featured Profile Article Have you faced the power of paper?
Current Poll
|
| Tango01 | 07 Sep 2023 5:05 p.m. PST |
"I cut the giant numbers from sheet styrene and mounted them on strips of scrap styrene. The GATE lettering was 3d printed as separate letters and then mounted on very thin square section styrene strip. To make that easy I taped long pieces of the styrene strip down to my cutting mat, glued the letters down, then once the glue had cured cut each word out…"
See here
link
Armand |
|
