"I've gone Prusa Fuzzy" Topic
2 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please don't make fun of others' membernames.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board
Action Log
13 Jul 2023 9:01 a.m. PST
by Editor in Chief Bill
- Changed title from "I've gon Prusa Fuzzy" to "I've gone Prusa Fuzzy"
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article
Current Poll
|
| UshCha | 13 Jul 2023 7:34 a.m. PST |
Its rare but my 3D simple prone flats at 1/144 scale have not been right since the Makerbot died. The Pruza slicer never got such small items correct. The legs were either 2 strands wide with a gap or missing altogether. Problem is they are a very close to the limit of what can be done on a 0.3mm nozzle. I was desperate so tried Fuzzy logic. It worked, it blurs the out line enough to fill in the gaps to an acceptable level. So if you have a Pruza and two perimeters too close that there is a gap but not for a single strand infill, this may be a solution. Happy printing (FDM of course) |
| Andrew Walters | 13 Jul 2023 10:29 a.m. PST |
That is interesting, I'll give that a try if I end up with that issue. It's always a puzzle when you look on the preview screen (in Cura) and see some small but important details is entirely omitted. |
|
worries about not losing his rules stuff.