Help support TMP


"Minden Redux Times Two" Topic


4 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please do not use bad language on the forums.

For more information, see the TMP FAQ.


Back to the SYW Message Board

Back to the 18th Century Battle Reports Message Board

Back to the 18th Century Discussion Message Board


Areas of Interest

18th Century

Featured Hobby News Article


Featured Link


Top-Rated Ruleset


Featured Book Review


829 hits since 28 Mar 2023
©1994-2024 Bill Armintrout
Comments or corrections?

Lascaris28 Mar 2023 8:43 a.m. PST

A follow on from my previous Minden AAR. I refought the battle using two sets of rules, Carnage & Glory (C&G) and Might & Reason (M&R). I tried to be a little more thoughtful this time in my approach, especially using C&G, as the rules move quicker than M&R and you can get punished pretty quickly for blindly charging in without preparation. Anyway, see the blog if interested.

carnivalempire.wordpress.com/2023/03/28/minden-redux-times-two/

Personal logo Dal Gavan Supporting Member of TMP28 Mar 2023 6:14 p.m. PST

Excellent game reports, mate, but the comparison between C&G and M&R was especially well done. I haven't played either (my preferred rules are Grant's, not a popular choice down here, though I play DBSYW as well, for a tricorne fix) but C&G is looking more and more interesting. Especially the campaign option.

Hal Thinglum Supporting Member of TMP29 Mar 2023 4:52 a.m. PST

Very interesting . I'd like to ask how you attach your labels. Thanks

Lascaris29 Mar 2023 8:28 a.m. PST

Because I was switching rules, and labels, back and forth this was just printer paper with scotch tape holding it on. If I 100% settled on a set of rules I'd probably print it on 65# paper, laminate it, and then figure out a more secure, but still removeable adhesive. Because my bases are a mix of bass wood and PLA (these days I just 3D print any bases I need) I would need to do a little experimentation to figure out the best method of adhering the labels for robustness.

Sorry - only verified members can post on the forums.