Help support TMP


"Check your six tray for stand" Topic


10 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please don't call someone a Nazi unless they really are a Nazi.

For more information, see the TMP FAQ.


Back to the 3DPrinting Message Board

Back to the WWII Aviation Discussion Message Board


Areas of Interest

General
World War Two in the Air

Featured Link


Featured Ruleset


Featured Showcase Article


Featured Workbench Article

Forest Bases on a Budget

Holy Roman Emperor Joseph III Fezian shows us that you don't need money to have great bases.


Featured Profile Article

The Simtac Tour

The Editor is invited to tour the factory of Simtac, a U.S. manufacturer of figures in nearly all periods, scales, and genres.


921 hits since 23 Mar 2023
©1994-2024 Bill Armintrout
Comments or corrections?

sgt Dutch Supporting Member of TMP23 Mar 2023 5:30 a.m. PST

Transporting your flight stand for CY-6 can be a pain. Specially with the ball magnets. These just love to grab each other. Using my CAD I made a carrying tray.

greenknight4 Sponsoring Member of TMP23 Mar 2023 11:11 a.m. PST

Inventive :)

The H Man23 Mar 2023 5:10 p.m. PST

But, there are nine.

The H Man23 Mar 2023 5:15 p.m. PST

Seriously though.

This is the kind of thing I don't get.

They look great and will work well, but…

Using a printer to print board seems a waste.

A laser cut (and I only say that because they are hexes) peice of mdf or ply or even plastic sheet sounds more appropriate.

It would definitely be cheaper and easier for mass production, but even for a one off, I'd expect.

Maybe that's another bit of kit people could look into.

Todd63623 Mar 2023 5:43 p.m. PST

Maybe he only has a 3D printer and not a laser cutter. Filament is cheap. Can't imagine that costing him much at all. He didn't mention mass production, so it probably isn't an issue. I think he wanted a way to carry his flight stands. Had CAD skills and a 3D printer. His problem was solved.

Sorry - only verified members can post on the forums.