"Assembling Minifig guns" Topic
6 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
For more information, see the TMP FAQ.
Back to the Napoleonic Discussion Message Board
Areas of InterestNapoleonic
Featured Link
Featured Showcase Article
Featured Workbench Article
Featured Book Review
|
| Wealdmaster | 12 May 2022 7:31 p.m. PST |
I've gotten my first Minifig Napoleonic howitzer. It has a sprue of tools, ammo crate, etc. On the sprue are two tiny donuts. They look like they might fit over the axle, but no because the hole is too small. I'm not sure where these go. |
 ColCampbell  | 12 May 2022 8:35 p.m. PST |
I think they are supposed to the the outer hubs for the wheels. You may have to enlarge the holes to make them fit. Jim |
| BillyNM | 12 May 2022 10:30 p.m. PST |
I think ColCampbell is right, espeially if they have two small protusions on either side like a split pin – see:
TMP link |
| Wealdmaster | 13 May 2022 10:20 a.m. PST |
Thanks, this is good info. Great photo! Mine don't have the pins protruding, but I can't see what else that would be. Will try to drill them a little. |
| HMS Exeter | 13 May 2022 4:03 p.m. PST |
An operational question. Would the gun crew have removed the chest suspended between the trails before firing? |
| 4th Cuirassier | 13 May 2022 6:18 p.m. PST |
|
|
gets started with Flintloque.
