"Pimp my Runabout!" Topic

6 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please use the Complaint button (!) to report problems on the forums.

For more information, see the TMP FAQ.

Back to the 28mm Sci-Fi Message Board

Back to the 20mm Sci-Fi Message Board

Back to the Star Trek Message Board

Back to the 15mm Sci-Fi Message Board

Back to the Conversions Message Board

Action Log

29 May 2021 12:26 p.m. PST
by Editor in Chief Bill

Crossposted to 28mm Sci-Fi board

Areas of Interest

General
Science Fiction

Featured Hobby News Article

Not Your Usual Flying Circus…

Core Space - Gak & Roykirk

Featured Showcase Article

Relthoza Swarm-Class Cruisers

Again from Blue Table Painting - this time, the Swarm-class cruisers for the Relthoza aliens.

Featured Workbench Article

CombatPainter Makes a Barbed Wire Section

combatpainter has been watching some documentaries lately set in the Western Desert, and was inspired to create this...

Featured Profile Article

First Look: Battlefront's Train Tracks

Editor in Chief Bill checks out some 10/15mm railroad tracks for wargaming.

Current Poll

Best Mech Rules (Round 1)

etotheipi	29 May 2021 3:41 a.m. PST
This is a nice little Trek ship model that could work for a large number of 28mm or 15mm milieu. And it is ripe for a little conversion project to light it up.
Bashytubits	29 May 2021 9:57 a.m. PST
Glow for it!
Oberlindes Sol LIC	29 May 2021 1:19 p.m. PST
well done!
dmebust	29 May 2021 6:45 p.m. PST
Agreed, well done!
BigNickR	08 Jun 2021 2:01 p.m. PST
I'm thinking of getting one and 3d print some openlock tiles for the decks plans
etotheipi	08 Jun 2021 3:55 p.m. PST
With this model, you could absolutely do that. Since you are not going to glue the base to the upper hull (lots of space in there), I would recommend neodymium magnets to hold it closed. You would probably want to add a "handle point" – just a little bit sticking out – for leverage to open and close it.