Help support TMP


"VMB 433" Topic


4 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please do not post offers to buy and sell on the main forum.

For more information, see the TMP FAQ.


Back to the WWII Media Message Board


Areas of Interest

World War Two on the Land
World War Two at Sea
World War Two in the Air

Featured Recent Link


Featured Showcase Article

Small Scale Ships with M.Y. Miniatures

Mal Wright Fezian's first experience with 1:4800 scale naval models.


Featured Profile Article

Editor Julia's 2015 Christmas Project

Editor Julia would like your support for a special project.


Current Poll


663 hits since 28 Jun 2020
©1994-2024 Bill Armintrout
Comments or corrections?


TMP logo

Membership

Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
Skeets Supporting Member of TMP28 Jun 2020 5:05 p.m. PST

I just found this site while searching for info: vmb433.com/index.htm. This was my father's unit in WW2. A lot of this information is from his squadron book. I didn't think this was still to be found as I believe there are no longer any surviving crew members.

79thPA Supporting Member of TMP29 Jun 2020 11:20 a.m. PST

Link "not found" for me.

Skeets Supporting Member of TMP29 Jun 2020 12:11 p.m. PST

Sorry, I was able to link to the site. When I did so I noticed there was a "Not Secure" warning. I have been going back and forth to this site since my father died so that notation may have been added a while ago since I have not gone there for a few years. Do you have a block?

Walking Sailor29 Jun 2020 1:48 p.m. PST

404 link not found
try: vmb433.com/index.htm
You have a period at the end of your link. Always put a space at both ends of your link post.
It also helps to test them after you have posted. Especially if you set more than one link. I have set the wrong link and needed to hit the edit button.

Sorry - only verified members can post on the forums.