Help support TMP


"Pyramid for the Necron Tomb Complex" Topic


2 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember not to make new product announcements on the forum. Our advertisers pay for the privilege of making such announcements.

For more information, see the TMP FAQ.


Back to the Terrain and Scenics Message Board

Back to the Warhammer 40K Message Board


Action Log

28 Jun 2020 11:12 a.m. PST
by Editor in Chief Bill

  • Changed title from "Hot Wheels drivers for Gaslands" to "Pyramid for the Necron Tomb Complex"Removed from Post-Apocalypse Discussion board
  • Changed starttime from
    28 Jun 2020 10:41 a.m. PST
    to
    28 Jun 2020 10:41 a.m. PST

Areas of Interest

General
Science Fiction

Featured Link


Featured Showcase Article

Small Storage Packs from Charon

When you only need to carry 72 28mm figures (or less)...


Featured Profile Article

Report from ReaperCon 2006

Michael Cannon reports from last May's ReaperCon 2006.


Current Poll


846 hits since 28 Jun 2020
©1994-2025 Bill Armintrout
Comments or corrections?

MechanicalHorizon28 Jun 2020 10:41 a.m. PST

Here's a few WIP pics of the Pyramid for the Necron Tomb Complex.

The parts are modular and will probably use the OpenLock system to connect them.

The large pyramid is made from 4 layers and the capstone. You can remove each layer to reveal the layers underneath.

The inside will also be detailed with separate wall sections, similar to the Zone Mortalis walls.

You can also mix and match the parts to make the pyramid different, or to make smaller pyramids.

picture

picture

picture

Sorry - only verified members can post on the forums.