"3D Printable Necron Tomb Complex WIP pics" Topic
2 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board Back to the Terrain and Scenics Message Board Back to the Warhammer 40K Message Board
Areas of InterestGeneral Science Fiction
Featured Hobby News Article
Featured Link
Featured Showcase Article
Featured Workbench ArticleWhen evolved Newts happen upon a WWII comic...
Featured Profile ArticleOur Man in Southern California, Wyatt the Odd , takes press pass in hand and reports from the Gen Con So Cal convention.
Current Poll
Featured Book Review
|
MechanicalHorizon | 19 Jun 2020 5:52 p.m. PST |
I've been working on a set of 3D Printable models to build a Necron-Themed Tomb Complex. There will be a few more wall sections, but for now there is the Entrance, connector, tower, and corner section. imgur.com/AVLjqnu imgur.com/2WH4lJv |
Pat Ripley | 23 Jun 2020 1:00 p.m. PST |
|
|