Help support TMP


"The joys of printing" Topic


1 Post

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.


Back to the 3D Printing Message Board


Areas of Interest

General

Featured Hobby News Article


Featured Ruleset


Featured Showcase Article

GF9 Fire and Explosion Markers

Looking for a way to mark explosions or fire?


Featured Profile Article

My Wargaming Blood Revealed

Personal logo Editor in Chief Bill The Editor of TMP Fezian gets his DNA results, and starts thinking about wargaming.


Current Poll


284 hits since 21 May 2020
©1994-2020 Bill Armintrout
Comments or corrections?

Tango01 Supporting Member of TMP21 May 2020 10:10 p.m. PST

"I mentioned the other day that I bought a 3d printer, well lockdown finally gave me that kick to use it properly and start learning how to use Blender to make my own models as everything I could find didn't quite fit the aesthetics I wanted. A few years back when I was on a resin casting kick, I tried sculpting/casting an extra wall to go with the GW Garden of Morr set as I loved the style… but hated all the skulls on it all. That didn't go so well as the plaster started to disinegrate in the wet rubber…"

picture

picture

Main page
link


Amicalement
Armand

Sorry - only verified members can post on the forums.