"Horror at Party Beach minis" Topic
5 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
In order to respect possible copyright issues, when quoting from a book or article, please quote no more than three paragraphs.
For more information, see the TMP FAQ.
Back to the Figure Finder Message Board
Action Log
27 Feb 2020 12:53 p.m. PST
by Editor in Chief Bill
- Changed title from "It is time to negotiate with al-Shabab" to "Horror at Party Beach minis"
- Changed starttime from
27 Feb 2020 11:07 a.m. PST
to
27 Feb 2020 11:08 a.m. PSTRemoved from Ultramodern Warfare (2009-present) board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Profile Article
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
| Slow Oats | 27 Feb 2020 12:08 p.m. PST |
Hi folks, I just watched "Horror at Party Beach" again recently, and it struck me that the climax of the film would make a great scenario for Fear and Faith. In it, our heroes chuck bricks of sodium at an oncoming horde of protozoa zombie monsters in the woods near an abandoned quarry. I could swear I'd seen someone making minis for this movie somewhere, but for the life of me I can't find them again. They were either 15mm or 28mm. Anyone know where they might be? Here's a picture of the monster:
|
| DyeHard | 27 Feb 2020 5:33 p.m. PST |
Here are some: From Khurasan, in 15mm
link
And this Roebeast from here:
link
|
| Slow Oats | 27 Feb 2020 9:51 p.m. PST |
I could've sworn I'd scoured Khurasan's sight top to bottom for these, don't know how I missed it. I also noticed the Ro-Man from "Robot Monster" in the catalogue, I might have to pick up a pack of those as well. Thanks a million, DyeHard. |
| Old Wolfman | 28 Feb 2020 8:56 a.m. PST |
"Get yer hotdogs here!"and don't forget the sodium. ;^) |
| Slow Oats | 29 Feb 2020 2:45 p.m. PST |
"Is there anyone who loves pickles as much as I do?" |
|
discusses the limitations and challenges of working with a low-end 3Dprinter.
