"3D Printable Eldar Outpost - New Backer Levels added" Topic

1 Post

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please do not post offers to buy and sell on the main forum.

For more information, see the TMP FAQ.

Back to the Terrain and Scenics Message Board

Back to the Not found! Message Board

Back to the 3DPrinting Message Board

Back to the 20mm Sci-Fi Message Board

Back to the 28mm Sci-Fi Message Board

Areas of Interest

General
Science Fiction

Featured Hobby News Article

Any-Scale Wyrde Obelisk Free Until End of Mega Event

Day 2: Bulat Depot

Top-Rated Ruleset

One-Hour Skirmish Wargames

Rating:

Featured Profile Article

3DPrinting: Striations, Surfaces, Wisps & Fusing

Editor in Chief Bill discusses the limitations and challenges of working with a low-end 3Dprinter.

The Membership System will be closing for maintenance in 9 minutes. Please finish anything that will involve the membership system, including membership changes or posting of messages.

MechanicalHorizon	30 Aug 2019 11:42 a.m. PST
I added a couple new backer levels to the Eldar Outpost. The first is set at $10 USD and lets you pic one of the buildings from the list below: Tall Tower Short Tower (this will include the balcony optional part) Watchtower Bunker Barracks The second is at $20 USD and gets you all of the wall sections, including the Gate Statues. link

Sorry - only verified members can post on the forums.