Help support TMP


"3D Printable Eldar Outpost - Gantry System Preview" Topic


3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember that some of our members are children, and act appropriately.

For more information, see the TMP FAQ.


Back to the Terrain and Scenics Message Board

Back to the Not found! Message Board

Back to the 6mm Sci-Fi Message Board

Back to the 3DPrinting Message Board

Back to the 20mm Sci-Fi Message Board

Back to the 28mm Sci-Fi Message Board


Areas of Interest

General
Science Fiction

Featured Hobby News Article


Featured Link


Featured Ruleset


Featured Showcase Article

GF9 Fire and Explosion Markers

Looking for a way to mark explosions or fire?


Current Poll


Featured Book Review


Featured Movie Review


1,773 hits since 28 Aug 2019
©1994-2024 Bill Armintrout
Comments or corrections?

MechanicalHorizon28 Aug 2019 7:57 p.m. PST

Here's a couple WIP pics of the Gantry system.

There's a straight section, L section, T section and 4-way section.

I'll be making railings to fit each section, plus armored plates that can attach to the railings.

I'll also be making a straight section with a wider center part so more troops can fit on it.

The pillars that hold it up will look organic, and I'm going to try to get end sections that will fit onto the buildings, so when you have the gantry meeting up with a door it looks like it's part of the structure.

picture

picture

link

Fish29 Aug 2019 1:25 a.m. PST

I do not understand how this KS hasn't been more successful. Awesome designs and not all that expensive.

Go figure…

MechanicalHorizon02 Sep 2019 8:27 p.m. PST

Here's a couple pics of new parts for the wall sections, an optional tower you can mount a heavy weapon on.

picture

picture

Sorry - only verified members can post on the forums.