"Getting Started 3D Model FV 601 Saladin" Topic
8 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please don't call someone a Nazi unless they really are a Nazi.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article Is there finally a gluestick worth buying for paper modelers?
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
| DrLoFil | 19 Jun 2019 1:58 a.m. PST |
Finally it will be possible to draw a 3d model
|
| Who asked this joker | 19 Jun 2019 3:13 a.m. PST |
Looking good. What software are you using to actually draw the model? |
| DrLoFil | 19 Jun 2019 3:17 a.m. PST |
Since now I have a rather "weak" laptop with me – I use 123D Design. Also used the Russian analog Solidworks |
| DrLoFil | 19 Jun 2019 8:15 a.m. PST |
|
| DrLoFil | 20 Jun 2019 8:34 a.m. PST |
|
| UshCha | 21 Jun 2019 9:35 a.m. PST |
To be honest I would put a key lock on the turret so it only comes off in one angular position much safer. You must be able to do it as I can on my 3D prints at 1/144. Not possible if you are going to cast from the 3D print (but who would). |
| DrLoFil | 04 Jul 2019 10:51 a.m. PST |
During the day Saladin FV601 will be ready. It remains to finish the turret and make a test print
|
| DrLoFil | 10 Jul 2019 3:07 a.m. PST |
After the first tests corrected errors. Sent to new print
|
|
