"I have been left Reeling!" Topic
5 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please don't make fun of others' membernames.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase Article
Featured Profile Article
Current Poll
Featured Book Review
|
Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
| UshCha | 14 Jan 2019 8:12 a.m. PST |
Having a bad experience. Same supplier, same brand but the current PLA is a real pain. The reel is poorly wound and so it fouls every couple of hours or less some times ruining the print if you can'y get it cleared very quickly. Typical that at the moment we want to run long 4+ hour prints. |
| Winston Smith | 14 Jan 2019 8:24 a.m. PST |
Sounds like pre-wound cord for sidewalk edgers. Luckily the grass is still there if you have to fix a jam. |
| Rob Richardson | 14 Jan 2019 1:59 p.m. PST |
Name and shame so no one else has to go through your pain. |
| UshCha | 14 Jan 2019 11:49 p.m. PST |
It was Filaprint Premium PLA. |
| IUsedToBeSomeone | 15 Jan 2019 3:13 a.m. PST |
I have had a couple of problems with badly wound reels that snag and break. I ended up using them for short time prints or where I can keep an eye on them and prevent the snag before it happens… Mike |
|
.
