"Re-scaling" Topic
3 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please avoid recent politics on the forums.
For more information, see the TMP FAQ.
Back to the 3DPrinting Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Workbench ArticleThese are not the seasonal figures that you might give your mother to put on the shelf!
Featured Profile ArticleLooking for inexpensive paint?
Current Poll
|
Oldguy | 09 Jul 2018 5:31 p.m. PST |
Any suggestions for printing 28mm dungeon furnishings at 15mm? |
Tgerritsen | 09 Jul 2018 5:41 p.m. PST |
Use this site to determine the percentages and have at. link |
Canuckinator | 09 Jul 2018 5:43 p.m. PST |
Printable Scenery put together a decent article on this very subject a while back: link |
|