Help support TMP


"Hexon II the missing pieces and boxes." Topic


3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember that some of our members are children, and act appropriately.

For more information, see the TMP FAQ.


Back to the 3DPrinting Message Board


Areas of Interest

General

Featured Hobby News Article


Featured Link


Featured Showcase Article

Lemax Christmas Trees

It's probably too late already this season to snatch these bargains up...


Featured Profile Article

Escaping to Paradise

Personal logo Editor Gwen The Editor of TMP has been spending time in paradise lately.


795 hits since 19 May 2018
©1994-2025 Bill Armintrout
Comments or corrections?


TMP logo

Zardoz

Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.
UshCha19 May 2018 1:52 p.m. PST

If anybody is interested I have designs for Boxes that are hexagonal with lids that function as Hexon 2 tiles (2 high and 4 high) so you can store markers without using additional storage space. Has anybody else done similar?
Also we have designed some of the missing pieces. A hex with 2 sloping sides and a ridge hex, 2 sloping sides either end.

Personal logo Dye4minis Supporting Member of TMP20 May 2018 9:29 a.m. PST

Any edge of table fillers so the sides can be flush and straight along the board's edge? (Like Geo-Hex have?)

Like your idea of hex boxes and storage areas.

UshCha21 May 2018 9:16 a.m. PST

Dye4minis, I have made standard 2 high hex pieces but not so far half slopes.
I was talking to Paul of Kallistra yesterday at Partisan, apparently he will cut hexes on half if you request it at the time of purchase, he had some on display.

Sorry - only verified members can post on the forums.