Help support TMP


"WAVING TRYING NOT TO DROWN..." Topic


4 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.


Back to the Plastic Army Men Message Board

Back to the Getting Started with SF Gaming Message Board


Areas of Interest

Science Fiction
Toy Gaming

Featured Hobby News Article


955 hits since 7 May 2018
©1994-2019 Bill Armintrout
Comments or corrections?

Plasticviking308 May 2018 12:37 p.m. PST

…under the pile of stuff I have accumulated.
Getting started has a phase of accumulation I find, where hoarding exceeds painting/making. I am mid-phase. Now under way to produce more. Still holding to the cheapnis principle.

If you are starting, Aliexpress, Amazon and Ebay can fill your gamesroom/workshop without emptying your pocket. Much. Maybe.

My struggles here.. link

cloudcaptain08 May 2018 1:17 p.m. PST

I like what you did with triceratops people. What putty are you using to bind the parts?

It's nice to finally see a scale reference on that Russian APC. Did you get yours from Aliexpress?

Plasticviking308 May 2018 1:36 p.m. PST

CC.. The APC was from Ali Express. Close to 1/35 I think. Other vehicles get too big for table I found.
I use old fashioned method to fit parts..I cut the join flat, set a pin in one side then superglue it as i push it home. Then i fill any gap with pva glue and paint. i have to say I am not after prizes… great you think they look ok.

John Leahy08 May 2018 2:29 p.m. PST

That was AWESOME!

thumbs up

Sorry - only verified members can post on the forums.