Help support TMP


"C96 Broomhandle In Holsters?" Topic


9 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember that some of our members are children, and act appropriately.

For more information, see the TMP FAQ.


Back to the G.A.S.L.I.G.H.T. Message Board

Back to the Pulp Gaming Message Board

Back to the Figure Finder Message Board

Back to the Conversions Message Board


Areas of Interest

General
Fantasy
19th Century
World War One
World War Two on the Land
Science Fiction

Featured Hobby News Article


Featured Link


Featured Showcase Article

Derivan Paints: Striking It Lucky With Colour

Sometimes at a convention, you can be just dead lucky and find a real bargain.


Featured Workbench Article

Drilling Holes in Minis - Part III: Going Larger

Personal logo Editor in Chief Bill The Editor of TMP Fezian weighs the pros and cons of using a power drill on the minis workbench.


Featured Profile Article

Gen Con So Cal 2006 Report

Wyatt the Odd Fezian reports from the final California Gen Con...


Featured Book Review


2,340 hits since 10 Jan 2018
©1994-2025 Bill Armintrout
Comments or corrections?

GARS190010 Jan 2018 7:07 p.m. PST

I'm looking to add holstered C96 Broomhandle pistols to the belts of some of my minis. Does anyone make these? I'm open to just holstered handguns I suppose, but I would prefer the C96 if its available.

surdu200511 Jan 2018 4:17 a.m. PST

I am not 100% sure, but I think you can get normal holstered pistols from The Assault Group.

Personal logo Mserafin Supporting Member of TMP11 Jan 2018 8:00 a.m. PST

Didn't the broom handle have a wooden holster that doubled as a shoulder stock?

The Shadow11 Jan 2018 8:11 a.m. PST

Mserafin

From what i've seen, the holster for the pistol and the holster for the stock were two separate holsters. They were not integral. I assume that the OP doesn't want both.

DyeHard11 Jan 2018 10:16 a.m. PST

Some quick reference:

Without stock:
link

With stock/holster:
link

The second might be the easiest to make from scratch, pretty much just trim some card stock.

capncarp12 Jan 2018 7:12 p.m. PST

I recently saw a video clip online that showed a selective-fire broomhandle Mauser with a shoulder-stock holster attached firing bursts until it was emptied. The firer then opened the holster, withdrew another broomhandle Mauser and fired another series of shots!

Fatman14 Jan 2018 1:15 p.m. PST

Not perfect but these might work.
link

link

Would a 54mm, which tend to bee closer to scale than 28mm, work?

Fatman

deflatermouse18 Jun 2018 1:39 a.m. PST

YouTube link

2:55 in

Personal logo Bobgnar Supporting Member of TMP21 Jun 2018 9:04 p.m. PST

Eric is not as articulate as the video above, but lots of interesting discussion.

YouTube link

Sorry - only verified members can post on the forums.