Help support TMP


"minotaur (28mm )" Topic


7 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.


Back to the 28mm Fantasy Message Board

Back to the Sculpting Message Board



498 hits since 11 Dec 2017
©1994-2018 Bill Armintrout
Comments or corrections?

Grimforge11 Dec 2017 7:38 a.m. PST

i have finished to sculpt this big guy for our wargame project.is made of fimo,beesputty and magic sculpt.
comment and critiques are welcome!
take a look to my fb page an give me a like to be updated on my project https://www.facebook.com/Grimforge

Personal logo Sir Walter Rlyeh Supporting Member of TMP11 Dec 2017 8:06 a.m. PST

I love the idea of a minotaur in plate! The armor looks functional but I think I would trim down the shoulder pad spikes. I can see the longhorns catching on them just at the wrong time! Awesome model and I would want one if it comes on kickstarter. For a model that size I might even get over my hatred of resin miniatures.

The Angry Piper Supporting Member of TMP11 Dec 2017 8:16 a.m. PST

WOW! That looks great!

I never thought about how a minotaur would look in a helmet, but now I know.

Awesome job, especially on the armor!

The Bibliophile11 Dec 2017 8:44 a.m. PST

Yep, agreed on reducing the size of the shoulder plate spikes. Impractical and a bit of stylistic overkill. Otherwise, a fantastic sculpt.

Will these be made available for purchase at some point?

--Joe

Hades wolf11 Dec 2017 9:21 a.m. PST

Not bad, agree with the shoulder pad comments, also it needs armour on its rear end otherwise it will be surrounded by enemies and a lucky one may stab it in the arse – ouch indeed :)

Glen

Personal logo Sir Walter Rlyeh Supporting Member of TMP11 Dec 2017 9:50 a.m. PST

On the linked Fakebook page it mentions an upcoming Kickstarter. I prefer metal models but for a big figure can see it if they go resin.

Grimforge16 Dec 2017 6:07 a.m. PST

sorry for the delay in the answer i was blocked but the "noobs 3 day posting block". thanks for the comments!
the spikes will be separated pieces then if you dont like a spike you can decide to dont glue it. the model will be printed in resin for a kickstarter with other 40 models. after the kickstarter will be available( if the kickstarter will be funded of course). for other questions feel free to ask!

Sorry - only verified members can post on the forums.