"looking for nicem spin caster" Topic

3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember that some of our members are children, and act appropriately.

For more information, see the TMP FAQ.

Back to the Moldmaking and Casting Message Board

Areas of Interest

General

Featured Hobby News Article

Brigade Models: "And Now For The Hard Work"

Wargaming Connection

Featured Ruleset

Politics By Other Means

Rating:

Featured Showcase Article

Stuff It! (In a Box)

Editor in Chief Bill worries about not losing his rules stuff.

Featured Profile Article

3DPrinting: Striations, Surfaces, Wisps & Fusing

Editor in Chief Bill discusses the limitations and challenges of working with a low-end 3Dprinter.

Wealdmaster	23 Jul 2017 12:34 p.m. PST
I'm going to start casting my own line of SYW 28mm figures that have been out of production for some time. I am looking to do the casting myself and need a machine that is quality and wonder if anyone out there has a nicem (hear they are the best) slightly used for sale?
Miniatureships	24 Jul 2017 9:39 a.m. PST
The nicem spin caster is most likely more machine than you will need. In the US and on the east coast I would look for something by Contenti or along that line. They are top loaders and easy to maintain.
Wealdmaster	25 Jul 2017 7:43 a.m. PST
Had a nice discussion with Contenti yesterday, also was suggested I look into a Conley.

Sorry - only verified members can post on the forums.