Help support TMP

"Help obtaining a 28mm girder bridge" Topic

5 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.

Back to the Historical Wargaming Message Board

Back to the Modern Discussion (1946 to 2007) Message Board

Back to the Early 20th Century Discussion Message Board

Back to the 19th Century Discussion Message Board

638 hits since 24 Jun 2017
©1994-2018 Bill Armintrout
Comments or corrections?

Brooklyn Wargamer24 Jun 2017 11:59 a.m. PST

Hello everyone:

I would like some help identifying and obtaining a 28mm more or less O scale Girder bridge:

I have seen some similar bridges on ebay, but what is particular is that it has only one diagonal girder from the top left to the bottom right then in the middle changes from top right to bottom left. The ones I've seen have crossed girders.







Please let me know if you can help.

Thanks in advance


A sea that raged no more24 Jun 2017 12:11 p.m. PST

Think that's a Truss bridge.


Check out Sarissa Precision's 28mm range.


Also includes a Girder bridge.


Personal logo Extra Crispy Sponsoring Member of TMP24 Jun 2017 1:05 p.m. PST

Sarissa is MDF so you could snip off unwanted girders.

Andoreth24 Jun 2017 3:31 p.m. PST

You might like to try these people.

Their model appears to be single strut to the centre span which is crossed and then single again, but they may able to make something like the bridge you want.

Brooklyn Wargamer25 Jun 2017 8:54 a.m. PST

Thanks everyone for your suggestions. I will look into them.


Sorry - only verified members can post on the forums.