Help support TMP

"Head Swaps" Topic

8 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.

Back to the American Revolution Message Board

403 hits since 14 May 2017
©1994-2017 Bill Armintrout
Comments or corrections?

two4slashing14 May 2017 9:50 a.m. PST

does anyone know if Kings Mountain head work with Warlord games minis?

Winston Smith Supporting Member of TMP14 May 2017 10:02 a.m. PST

I have used his heads on Old Glory, Perry and Conquest.
I NEVER comment on "compatibility". That's purely a judgement call of the person doing the comparing.
If you find Warlord compatible with any of the above, go for it.

d88mm1940 Supporting Member of TMP14 May 2017 12:25 p.m. PST

I saw somewhere that a head should about 1/6 of a persons height.

Bill N14 May 2017 1:13 p.m. PST

I have used the dragoon heads on WF/Warlord Continental light infantry figures to create Pulaski Legion foot. The heads are slightly larger than the plastic WF/Warlord heads, but I think they look OK.

The one problem you will run into is that unlike KMM figures where the neck is on the figure, the neck on WF/Warlord figures is on the head piece. The attachment pin on the KMM heads is too thin to pass for a neck with stock. You will need to fashion your own. The first batch I did I used putty to make a neck.

two4slashing14 May 2017 3:18 p.m. PST

Thanks, I am doing the 2nd Canadian and I'll give it a whirl

nevinsrip Sponsoring Member of TMP14 May 2017 8:27 p.m. PST

I used Battle Honors figures with KMM heads.
I don't think that KMM and Warlord are a good match and I own KMM.







dBerczerk16 May 2017 5:57 a.m. PST

Great photos of an impressive unit!

two4slashing01 Jun 2017 10:05 p.m. PST

Very nice, they would look great in my Battle of Staten Island.

Sorry - only verified members can post on the forums.