"3D-Printed Zeppelin Kickstarter " Topic
3 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
In order to respect possible copyright issues, when quoting from a book or article, please quote no more than three paragraphs.
For more information, see the TMP FAQ.
Back to the Victorian SF Message Board Back to the Not found! Message Board Back to the 3DPrinting Message Board
Areas of InterestGeneral
19th Century
Science Fiction
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article A fourth set of Romanian villagers from Blue Moon's boxed set.
Featured Profile Article
|
| Tango01 | 22 Dec 2016 10:06 p.m. PST |
Falkenwelt Modellbau is running a Kickstarter camapign for their 3D-printed Zeppelin link Main page
link Amicalement
Armand |
 Bobgnar  | 23 Dec 2016 10:15 a.m. PST |
Perhaps a good model for 2 mm or 6 mm. Pretty rough looking, I thought Zepplin skins were fairly smooth. I didn't realize this was for a fantasy game until I saw the caterpillar pulling the fuel tank. Not a Catapillar tractor but a pre-butterfly caterpillar |
| TheBeast | 23 Dec 2016 11:20 a.m. PST |
Zepplins did, though I assume the Count did some blimps early in his career that had his name on them… ;->= I think you're bang on on the 'rough' part. I think the bag too small for the gondola, though I'm actually taken with it independently as an aeronef. Doug |
|
reports from the final California Gen Con...