"FIMO air + UHU + Humbrol enamel paint + gloss varnish ???" Topic
5 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please do not use bad language on the forums.
For more information, see the TMP FAQ.
Back to the Scratchbuilding Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Recent Link
Featured Showcase Article
Featured Profile ArticleThe final installment of our ReaperCon report.
Current Poll
|
herr zinnling | 29 Oct 2016 8:50 a.m. PST |
Hello. Can I combine the following materials? air drying modelling clay (FIMO air) UHU extra ALL Purpose Adhesive Humbrol enamel paint + gloss varnish Regards, Karl |
GildasFacit | 29 Oct 2016 9:14 a.m. PST |
If the Fimo is thoroughly dry it would probably work but water in the clay would prevent the adhesive & paint bonding to the porous surface. Personally I'd use PVA & craft acrylics. |
Joes Shop | 29 Oct 2016 9:20 a.m. PST |
|
John Treadaway | 29 Oct 2016 12:35 p.m. PST |
I've only used Das air drying clay but that responded well to both PVA and aerosol car primer followed by traditional Humbrol (this was 3 decades ago…). Didn't use Uhu, mind you. John T |
herr zinnling | 02 Nov 2016 8:03 a.m. PST |
Thanks for the help! I did a test with UHU and Humbrol Enamel paint and it worked fine. But in the end I used Milliput (yellow-grey) to "glue" different pieces of clay together. Cheers, Karl |
|