"Gripping Beast, Crusader, and Foundry comparison" Topic
4 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please do not post offers to buy and sell on the main forum.
For more information, see the TMP FAQ.
Back to the Medieval Discussion Message Board
Areas of InterestMedieval
Featured Hobby News Article
Top-Rated Ruleset
Featured Showcase Article
Featured Workbench Article
Featured Profile Article
|
| Robert Burke | 18 Jun 2013 12:36 p.m. PST |
I've recently started playing SAGA and was wondering how the Gripping Beast Miniatures compare in size to Crusader and Foundry miniatures? I like the fact that Crusader has Irish warriors armed with slings. Can I mix these three manufacturers in the same unit? |
| Garand | 18 Jun 2013 12:42 p.m. PST |
IMHO the Crusader figures are a tad more bulky than Gripping Beast. That being said, I don't think mixing would be that much of an issue (they are of similar height), especially if they are kept in seperate units. Foundry it depends on the range. FREX I think the old Viking range mixes OK with Gripping Beast, but I don't know about the new range (if the new range and the old range mix well, there is your answer). Damon. |
| Mirosav | 19 Jun 2013 7:43 a.m. PST |
Crusader and GB are close. I use them in separate units for my Scots and they are fine. You could probably mix them in the same unit if you aren't too picky. I have Crusader, GB and Foundry Vikings all mixed together and they look good. |
| Cerdic | 19 Jun 2013 12:37 p.m. PST |
Here you go. Plenty of comparison photos here… link |
|
gets medieval.
