"28mm Armoured Car : The Ratel" Topic

8 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please don't call someone a Nazi unless they really are a Nazi.

For more information, see the TMP FAQ.

Back to the 28mm Sci-Fi Message Board

Areas of Interest

Science Fiction

Featured Hobby News Article

3Dprintable Zephyros Coalition Starter Fleet for Ironclads of Ferrosia

Little Boxes Made of Tin

Featured Showcase Article

Elite Avians & Felines, Plus Minotaurs

Part Three of our look at the Distant Worlds 12mm sci-fi line.

Featured Workbench Article

Storing the Mechanoids

Finding a solution when the army is too tall.

Featured Profile Article

Gen Con So Cal 2004

Our Man in Southern California, Wyatt the Odd , takes press pass in hand and reports from the Gen Con So Cal convention.

whiffwaff	02 Jun 2012 1:26 a.m. PST
Received this today from the printers. 28mm sized Armoured Scout Car. This was a test print, but am very pleased with the results. The Print lines, whilst visible are actually pretty none existent. I've taken some moulds of the surface this morning and am confident that once the model is cast and primed they wont be an issue at all. Am working on a few extra weapon options too. Scaled to work with figures on round slottas. Absolute nightmare to photograph this new material though! Cheers Adam
ZULUPAUL	02 Jun 2012 1:58 a.m. PST
Looks interesting. I've always liked scout cars for some reason.
Pat Ripley	02 Jun 2012 2:20 a.m. PST
amazing
LeadLair76	02 Jun 2012 4:07 a.m. PST
Excellent look. What did you print that on?
Dentatus	02 Jun 2012 5:20 a.m. PST
It's in cloak mode. Looks cool.
Chuckaroobob	02 Jun 2012 7:16 p.m. PST
I'd buy a few if I could figure out a camo paint scheme.
Lion in the Stars	02 Jun 2012 10:43 p.m. PST
Heh… I'm starting to think that I need to chuck a few Infinity minis into a 3d scanner and get them printed in Frosted Ultra Detail as TO Camo and/or Holoprojector markers. Or hit Corvus Belli with the idea, though I fear that the 3d printed minis would be more expensive than CB's metal minis…
freecloud	03 Jun 2012 2:36 a.m. PST
Its not a Ratel, its an Eland :)