"28mm Tonto Figure?" Topic
7 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
For more information, see the TMP FAQ.
Back to The Old West Message Board
Areas of Interest19th Century
Featured Hobby News Article
Featured Link
Featured Ruleset
Featured Showcase Article Whatever happened to the Boogey Men?
Featured Profile Article Our Man in Southern California, Wyatt the Odd, reports on the Gamex 2005 convention.
|
| Mick A | 02 Dec 2011 6:54 a.m. PST |
I've just got hold of one of Artizans limited edition Lone Ranger figures but he really needs a Tonto figure to go with him, any suggestions? Thanks in advance, Mick. |
| Mick A | 02 Dec 2011 8:21 a.m. PST |
Well thats one solution. Trouble is, it would be daft singing the William Tell Overture without him on the table… :o) Mick |
| cavcrazy | 02 Dec 2011 8:35 a.m. PST |
Too bad they don't make the figure mounted…..but if you get two there could be a conversion…..As for a Tonto figure?, I'm sure you can do a nice figure of Tonto using a Foundry Apache and a little bit of the green mili-put…just a thought. |
| sneakgun | 02 Dec 2011 8:40 a.m. PST |
Stone Mountain makes one, they're not listed on the site, send him an email…. |
| cavcrazy | 02 Dec 2011 10:33 a.m. PST |
Stone Mountain does 28mm? |
| sneakgun | 02 Dec 2011 2:31 p.m. PST |
|
|
