|
|||||
| Revision Log | |
| 15 January 2008 | page first published |
DemosLaserCutDesigns 
"expands his knowledge" by venturing onto the high frontier.
The Editor is fresh back from GenCon, one of the largest gaming conventions in North America.
5,955 hits since 15 Jan 2008
©1994-2025 Bill Armintrout
Comments or corrections?
The G Dog writes:
Cut out a square of styrene measuring 3" by 3". Thickness of the base is not critically important, but thicker is generally better as it will minimize warping that may occur with the Flex Paste.
Next, cut off the corners on the base, and use the file to round the edges smooth.
