|
|||||||
| Revision Log | |
| 20 December 1999 | page split off |
| 10 October 1999 | page first published |
Rating: 
Editor in Chief Bill 
attempts to 3Dprint and paint some 28mm fantasy figures.
The Editor tries out this first-year gaming convention in the San Francisco Bay Area (California).
5,615 hits since 5 Jan 2000
©1994-2025 Bill Armintrout
Comments or corrections?
Warrior wears a lined fur cloak, a large left-shoulder pad, gauntlets, boots with kneeguards, and loincloth hanging from belt about her hips. A decorative Earth Mother symbol hangs over the loins, and itself suspending a large tassel. Fur "stole" hangs around neck, ending with claws over chest. Thighs are bare. Short hair. Sword with simple decoration on lower blade.
(Essentially, same equipment as Figure #2 except - gauntlets slightly different, some areas not visible due to pose, very different pose.)
Seams are visible on cloak lining, very minor.
Figure is 29mm tall (from top of head to bottom of boot). Two per boxed set.
