Help support TMP


POLL: Best Material for 15mm Sci-Fi Vehicles?


157 votes were cast.


Back to POLLS home page


unknown member writes:

Unobtainium!

It's light, strong, low cost, low melting point, easily moldable, easy to cut, comes in any color you want and makes that "PEW PEW PEW" sound when you move them around.


Back to the Homepage



1,442 hits since 17 Jun 2010
©1994-2018 Bill Armintrout
Comments or corrections?

The Membership System is temporarily offline for maintenance. It should be restored shortly.

If you were a member of this website, you could participate in website polls. Would you like a free membership?

VOTING RESULTS
AnswerVotes%Chart
no preference
22
14%
bar of chart
lead
8
5%
bar of chart
no opinion
6
4%
bar of chart
not interested in 15mm sci-fi
36
23%
bar of chart
other
0
0%
 
resin
46
29%
bar of chart
plastic
20
13%
bar of chart
pewter
19
12%
bar of chart
POLL IS CLOSED
POLL DESCRIPTION

unknown member wonders...

I'd like to know which medium people prefer for the 15mm Sci-Fi vehicle hulls and turrets?

For small, thin weapons, we will most likely produce these in metal, or other robust materials, for added strength.

Larger weapons can be produced in any of the above materials.

Please specify your preference for the above, assuming the following:
  • the cost of the resin and lead miniatures may be about the same;
  • it is currently believed that the cost for pewter miniatures will be about 50%100% more than the cost for miniatures made of lead, or resin

(Nominations taken from this pre-poll discussion.)