Help support TMP


Extra Turrets: 3Dprintable for 28mm Wargames


Back to Hobby News


Areas of Interest

Science Fiction

Featured Hobby News Article


Featured Link


Featured Ruleset


Featured Workbench Article

Drilling Holes in Minis - Part I

Personal logo Editor in Chief Bill The Editor of TMP Fezian experiments with Finger Drills.


Featured Book Review


Featured Movie Review


688 hits since 3 Nov 2021


©1994-2022 Bill Armintrout
Comments or corrections?

Wargame Vault announces the availability of:

From Tabletop Terrain

ZIP File – $5.00 USD

Extra Turrets

Extra Turrets is an expansion kit of 3Dprintable files that contains two new turrets that can be used with our LAV and tank kits. They have been designed to print easily in FDM and resin, and to work with 28-32mm scale figures.

Components

The Extra Turrets kit has core components and variant pieces. Included are:

  • An AA/Anti-Aircraft Turret with multiple weapon options, including cannon, gatling weapons, and surface-to-air missiles
  • An Autoloader Tank Turret with a variety of three crew weapons, and a variety of tank and other main guns
  • A scanning radar dish that replaces the small top turret hatch. This part is resin-printable only

Build instructions and photos are included. This is an expansion kit, and will require owning our LAV or tank kits to build a complete vehicle.

Extra Turrets: 3DPrintable for 28mm Wargames

Extra Turrets: 3DPrintable for 28mm Wargames

Victoria Miniatures figures are for scale only. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.

Printing

This is a kit and requires assembly. The pieces are designed to be printed on a home FDM 3Dprinter with:

  • A 0.4mm nozzle
  • 0.08-0.12mm layer height
  • 15-20% infill
  • Supports are only required for a few of the .STL files
  • Rafts may be required for the smaller parts, depending on your 3Dprinter

All .STL files are oriented correctly, so you can load them into your slicer and print them immediately. The parts have been designed to print face-up for the best detail. All .STL files were sliced using Cura and test printed on a Creality Ender 3. All resin parts were test-printed on a Creality LD-00R2 resin printer.

Previews

Extra Turrets: 3D Printable for 28mm Wargames

Extra Turrets: 3D Printable for 28mm Wargames

The RWCS system from the tank kit can also be used with the AA turret as shown.

Extra Turrets: 3D Printable for 28mm Wargames

Extra Turrets: 3D Printable for 28mm Wargames

For more information

Extracted by Editor Dianna
Text edited by Editor Dianna
Graphics edited by Personal logo Editor in Chief Bill The Editor of TMP Fezian
Scheduled by Personal logo Editor in Chief Bill The Editor of TMP Fezian