"3D Prints" Topic

3 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please do not use bad language on the forums.

For more information, see the TMP FAQ.

Back to the 3DPrinting Message Board

Back to the Cold War (1946-1989) Message Board

Back to the Renaissance Battle Reports Message Board

Back to the Modern Aviation Discussion (1946-2011) Message Board

Areas of Interest

General
Renaissance
Modern

Featured Hobby News Article

Longest Road Available for Next War

Yarkshire Gamer Podcast - Episode 5 - Mark Freeth - Wargames Holiday Centre

Featured Ruleset

GRIT Multigenre Miniatures Rules – Basic Rules

Rating:

Featured Showcase Article

Modern Roads Expansion From Battlefront/Battlefield in a Box

Editor in Chief Bill tries out the expansion roads set.

Featured Workbench Article

Hasslefree's Morgan & Tony

With clean lines and not a lot of clutter, Minidragon says these figures are a painter's dream!

Featured Profile Article

Council of Five Nations 2010

Editor in Chief Bill is back from Council of Five Nations.

Featured Book Review

Trumbo

Bernhard Rauch	23 May 2023 8:40 p.m. PST
Looking for someone to 3 D print some 1:285 scale aircraft for me for a fee. The guy I used to use went out of business. Does anyone have any recommendations?
Mr Elmo	24 May 2023 4:49 a.m. PST
A basic 4K printer is $169 USD these days. At some point the cost of printing becomes more than the printer. Especially when considering all the future printing vs buying.
greenknight4	24 May 2023 11:35 a.m. PST
Have a look at dobpod.com Chris

Sorry - only verified members can post on the forums.