Help support TMP

"Chinese fighting junk" Topic

8 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.

Back to the Classical Asian Warfare Message Board

Areas of Interest


Featured Hobby News Article

Featured Link

Top-Rated Ruleset

Days of Knights

Rating: gold star gold star gold star gold star gold star gold star gold star 

Featured Workbench Article

Painting a 15mm Tibetan DBA Army: The Cavalry

Don't let the horses daunt you!

Featured Profile Article

Report from Bayou Wars 2006

The Editor heads for Vicksburg...

Featured Book Review

430 hits since 7 Jan 2021
©1994-2021 Bill Armintrout
Comments or corrections?

The Membership System will be closing for maintenance in 11 minutes. Please finish anything that will involve the membership system, including membership changes or posting of messages.

sgt Dutch07 Jan 2021 1:37 p.m. PST

My latest 3d print. The model is from the I Lovecraft Orient collect of 3d prints. Total time 88 hours of printing time. Next step is to paint the Junk. Primer will be the problem as it is too cold outside.

Mpre info can be found here:

mghFond07 Jan 2021 2:04 p.m. PST

Love the dragons on the side. Impressive.

Personal logo PaulCollins Supporting Member of TMP07 Jan 2021 6:47 p.m. PST

She's a beauty.

HMS Exeter08 Jan 2021 9:49 a.m. PST

88 hours!?!

I dont know from 3d printing. Did you have to "change the resin spool?" Tech unnerves me. I'd be afraid it'd stop, having run out of goopy, then lose its place, or not adhere to the cooled base, once it restarted.

David O Brien08 Jan 2021 4:43 p.m. PST

How much did those 88 hours of electricity cost you?

skipper John Supporting Member of TMP09 Jan 2021 7:35 a.m. PST

Sorry, but my first thought was a bunch of naked Chinese fellows wrestling in a big pile…

sgt Dutch10 Jan 2021 6:03 p.m. PST

David maybe a dollar. The printer are all 12 volt systems. Nothing more than running your computer at home.

sgt Dutch10 Jan 2021 6:06 p.m. PST

quarter to half a spool. I would have to look at my notes. If you have a filament sensor. The printer will stop and hold its place. I run the print on two 3d printers.

Sorry - only verified members can post on the forums.