"1/56 Metal Barrels?" Topic
4 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the WWII Discussion Message Board Back to the 28mm WWII Message Board
Areas of InterestWorld War Two on the Land
Featured Hobby News Article
Featured Link
Top-Rated Ruleset
Featured Showcase ArticleSoviet women were tough!
Featured Workbench ArticleThe Editor returns to paper modeling after a long absence.
Featured Profile Article
Featured Movie Review
|
DukeWacoan | 28 May 2020 11:20 a.m. PST |
Does anyone make 1/56 metal barrels to match resin kits? I have a few JTFM and other kits and the resin barrels just always bend a bit, etc. |
15mm and 28mm Fanatik | 28 May 2020 12:42 p.m. PST |
What tanks do you need them for? Here's a starting point, I guess. auction link |
monk2002uk | 28 May 2020 2:04 p.m. PST |
Selection of brass barrels available on Wargaming3D: link Robert |
Chuckaroobob | 28 May 2020 6:35 p.m. PST |
Hold the resin barrel under hot water, then bend very carefully. |
|