"The neck bone is connected to the shoulder bone..." Topic
3 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Remember that you can Stifle members so that you don't have to read their posts.
For more information, see the TMP FAQ.
Back to the Fantasy Gallery Message Board Back to the 3DPrinting Message Board
Areas of InterestGeneral Fantasy
Featured Hobby News Article
Featured Link
Featured Showcase Article
|
Waco Joe | 25 Jul 2019 6:08 a.m. PST |
Having some more fun in 88mm scale. Thingiverse maker Ilhadiel created a "some assembly required" skeleton.
Using that I was able to create a skeleton knight. I enlarged the pieces 300 percent and printed off a set in PETG. Then using Slic3r to cut each piece off the base and imported them into Cura where I could merge them into the pose I desired.
Black primer, and shades of drybrushing later I get a nice serviceable model. They are a little rough since I print in fast mode rather than detail. These are toys for the grand kiddos so no need to spend the 2-3X more time to print.
|
chicklewis | 25 Jul 2019 8:00 a.m. PST |
That is a great mini !! Wondering how many minutes before your grand-kiddos break such a fragile toy? |
bsrlee | 25 Jul 2019 11:48 p.m. PST |
He's used PETg – that's the stuff they make plastic soft drink bottles from, so its going to be pretty durable – more likely the paint will flake off if someone tries to turn them into a pretzel. |
|