"28mm Horse and Rider? Superglue them!" Topic
3 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please remember that some of our members are children, and act appropriately.
For more information, see the TMP FAQ.
Back to the Tools of the Hobby Message Board Back to the Pre-Paint Preparation Message Board
Areas of InterestGeneral
Featured Hobby News Article
Featured Link
Featured Showcase ArticleWell, they're certainly cheap...
Featured Profile ArticleFundraising for our Christmas charity project.
Featured Book Review
|
Editor in Chief Bill | 18 Feb 2019 12:56 p.m. PST |
You were asked – TMP link Favorite Adhesive for 28mm Horse and Rider?52% said "any superglue" 8% said "brush-on gel superglue" 3% (tie) said "greenstuff" or "JB Weld" or "contact cement" |
Winston Smith | 20 Feb 2019 3:06 p.m. PST |
They're wrong. 5 minute epoxy is best. |
von Schwartz | 21 Feb 2019 6:34 p.m. PST |
Obviously the 52% never used "gel" superglue. Far superior to the older less viscous superglue which inevitably ran all over and ended up with 2 or more fingers glued together, if you were lucky, cuz it was usually more than 2 fingers. Also, the "gel" is easier to clean out of the spout and you aren't tossing away so many half full tubes. |
|