Help support TMP


"Dismounted? Similar..." Topic


4 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Remember that you can Stifle members so that you don't have to read their posts.

For more information, see the TMP FAQ.


Back to the Wargaming in General Message Board


Areas of Interest

General

Featured Hobby News Article


Featured Link


Featured Showcase Article

3 Giant Succulents

Back to the plastic jungle…


Featured Profile Article

Gwen's Brother-in-Law Comes Home

Thanks in part to your donations, Personal logo Editor Gwen The Editor of TMP's brother-in-law has been able to leave the hospital after his cancer operation.


540 hits since 22 Aug 2018
©1994-2024 Bill Armintrout
Comments or corrections?

Personal logo Editor in Chief Bill The Editor of TMP Fezian22 Aug 2018 11:39 a.m. PST

You were asked – TMP link

How close are your dismounted figures and mounts to your mounted figures?

32% said "Each mounted/dismounted pair has the same uniform"
22% said "My figures will dismount when you pry the saddle from their cold, dead, groin"
13% said "Each mounted/dismounted figure is the same person"

JimDuncanUK22 Aug 2018 2:45 p.m. PST

All my 30mm Spencer Smith ACW cavalry have both mounted and dismounted figures as well as empty horses and horse holders.

Personal logo Bobgnar Supporting Member of TMP23 Aug 2018 1:29 p.m. PST

Ditto to Jim for my VBCW mounted figures, whether on bicycles, horses or motorcycles.

Anyone recall Jack Scruby's plan for dismounting figures? He made the riders with a long sword to form a tripod with legs of riders, so you could just take the figures off the horses and they would stand up.

khanscom23 Aug 2018 7:17 p.m. PST

For figures without swords Jack used to solder a length of steel wire on one foot; left unattached to the horse, this "ski" would allow the figure to stand on the table without the necessity of a separate dismounted stand.

Sorry - only verified members can post on the forums.