Help support TMP


"Market=Garden Kickstarter for 3D printing" Topic


4 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.


Back to the 3D Printing Message Board



545 hits since 7 Mar 2018
©1994-2018 Bill Armintrout
Comments or corrections?

Rev Zoom07 Mar 2018 10:34 p.m. PST

This looks to be really good.

link

Wackmole9 Supporting Member of TMP08 Mar 2018 5:13 a.m. PST

Very nice, but i wish it would be scaled to 6mm

darthfozzywig Supporting Member of TMP08 Mar 2018 10:01 a.m. PST

They note you can scale down below 10mm, but some details will be lost. Worth experimenting.

kencoleau Inactive Member08 Mar 2018 8:37 p.m. PST

I am in on this KS and plan to scale down to 6mm. I queried the scales/sizes and they are very close to 1:1 scaled down so Arnhem bridge is near 6 ft @ 28mm and at 6mm it should print fine. Some of the railings may not print but I am not worried about that.

My calculations make Arnhem bridge arch section still 400mm long so that should print fine at 6mm.

I actually came in here today to put the link up myself! :-)

Sorry - only verified members can post on the forums.