"Wire wool" Topic

1 Post

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

Please remember that some of our members are children, and act appropriately.

For more information, see the TMP FAQ.

Back to the 3DPrinting Message Board

Areas of Interest

General

Featured Hobby News Article

Print & Paste Textures: Modular Rivers Available

Lead Adventure Forum

Featured Ruleset

Simply Skirmish

Featured Showcase Article

Heroscape: Road to the Forgotten Forest

It's a terrain expansion for Heroscape, but will non-Heroscape gamers be attracted by the trees?

Featured Profile Article

Crafter's Square Cutting Pads

At last!

Current Poll

Best Ruleset That Never Caught On (Final Round)

Featured Book Review

Tracing Your Ancestors Using DNA

Please sign in to your membership account, or, if you are not yet a member, please sign up for your free membership account.

UshCha	04 Feb 2018 11:40 a.m. PST
I have now printed one of my largest parts in area terms on my Lexan base plate. I have had huge troubles getting large areas to stick. My final solution is to use wire wool as an abresive to roughen the surface of the plate, worked great, bit of a faf to get the part off but a small price to pay for not getting the part lifting during the print. This may help other folk with the same problem.

Sorry - only verified members can post on the forums.