"Pre-Orders open for the Second Wave of Hysterical Utopians!" Topic
10 Posts
All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.
Please do not use bad language on the forums.
For more information, see the TMP FAQ.
Back to the Spaceship Gaming Message Board
Areas of InterestScience Fiction
Featured Hobby News Article
Featured Link
Top-Rated Ruleset
Featured Showcase ArticleFrom a little-known range of science-fiction microarmor: the Heavy Hover Tank from C in C.
Featured Profile Article
Featured Movie Review
|
stumer | 16 Jan 2018 1:05 p.m. PST |
Alrighty then! Joining the Hysterical Utopians fleet are several new ship designs, as well as some re-scaled versions of the designs, in the 2nd Wave. These lower pre-order prices will change when I get everything into full production next month, but I need to "Kick-Start" the 3D Printed masters now after months of drawing. Let the Pre-Orders begin!
link |
Lion in the Stars | 16 Jan 2018 1:43 p.m. PST |
|
Lfseeney | 16 Jan 2018 10:41 p.m. PST |
Would the shuttles work for 6mm? Nice for Medical and Civ Units. How long and Tall please. |
stumer | 17 Jan 2018 10:47 a.m. PST |
The lengths are about 19mm (3/4") and 13mm (1/2"), with the height around 9mm (3/8") if that helps. |
stumer | 20 Jan 2018 11:10 a.m. PST |
We are at 40% funded to get the masters 3D printed! |
stumer | 24 Jan 2018 6:02 a.m. PST |
We are now at 60% funded to get these new designs 3D printed! Lets keep up the momentum of pre-orders so I can have them shipping next month! |
stumer | 26 Jan 2018 3:24 p.m. PST |
We are now at about 75% funded to get these new designs 3D printed! Lets go! |
stumer | 30 Jan 2018 5:38 p.m. PST |
We are almost there! We're at about 92% funded to get these 3D printed! link
|
stumer | 01 Feb 2018 1:13 p.m. PST |
We're funded for the 3D printed masters! They're ordered, and I want to thank everyone that pre-ordered to make these happen! |
stumer | 19 Feb 2018 6:34 p.m. PST |
I am now in stock in everything but the Heinlein Battleship and the Campbell Battle-Cruiser (which have resin parts), and the Goliath Heavy Shuttle which had problems molding and will need a mode before prototyping again. I received the prototypes right before leaving for the Farpoint Convention, and as soon as I got back started cleaning up all of the 3D prints to get ready for molding. I have limited stock right now, but I will be casting more this week. I wish I could say when the two resin ships will be available, but hopefully they will be shipping before the end of February. link |
|