Help support TMP

"Off With His Head" Topic

2 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

For more information, see the TMP FAQ.

Back to the 18th Century Discussion Message Board

616 hits since 29 Sep 2017
©1994-2018 Bill Armintrout
Comments or corrections?

Justin Penwith Inactive Member29 Sep 2017 8:45 a.m. PST

Wherein I mention a frustration with casting and seek assistance.


Camcleod29 Sep 2017 9:32 a.m. PST

Sounds like you mention. Cut a few air escape channels.
If along the mould join line a VERY thin channel cut with an x-acto knife will work.
If the trouble area is in the body of the mould a small hole poked thru with a small drill bit should work. Aim the hole toward the pour channel end.

Sorry - only verified members can post on the forums.